As the operation at home in the ceiling and the walls begin to crumble, and joints are beginning to penetrate styki.V rain water, which causes rotting of wood or maceration of the solution. At low temperatures it turns into ice increasing disclosure of seams and joints. It is therefore important to monitor their condition and maintain it in good vide.V wooden houses is necessary to monitor seams between planks or logs laid. Outside, they must be closed flat strips and aprons, and the inside of the flat strips and strips. A lot of seams and joints appears in interior decoration. For example, a binder or a reel, cover sheets of plywood or drywall using gvozdi.Pri revealed that the gap between the plates, rolling to a plaster smeared with a mixture of the following obrazom.Na knurled surface with a chisel or a hatchet. Recently Sander Gerber sought to clarify these questions. After the surface becomes rough, prepare a small portion of the plaster mixture as follows: 1) 1 part plaster at 2-3 parts sand 2) 1 part plaster of 0.5 – 1 part sawdust or wood shavings is desirable to add a little detergent any type of 'Fury', or washing poroshok.Smes mixed with water until thick dough and fill the seam with this solution, after drying solution sheathe potolok.Pri building rafters filly, which later beat a curtain board to paint over oil paint, open joints in brick houses and shvy.V joints and seams in places bearing embroidered panels on the various structural elements of the house.

For sealing can be applied grout. At the same time be filled with the ends wrapped structures ruberoidom.Esli joint width of 10-50 mm, it zachekanivayut grout, if the 50-300mm – with concrete. The gaps between the brickwork and boxes of windows and doors, carefully prokonopachivayut felt or Paley soaked in a solution of gypsum. For large gaps of 40 mm and above can use strips of roofing felt, pushing them into the slot. If you work behind a layer of plaster, but not collapsed, you need to drill this layer and fill the syringe into the cavity PVA glue or others with plywood and then press the rack or a wedge..